Measuring is one of the most important parts of the process. Having correct measurements will save the aggravation of running out in the middle of a job to get more supplies. There are different sizes and thicknesses of drywall. If you are new to this type of work it will be easier to use drywall sheets that are four feet wide by eight feet long and 1/2 inch thick for walls and 5/8 inch for ceilings. Green board will be required if doing a bathroom or another area that will be prone to moisture.
To get the measurements needed, measure the complete area floor to ceiling and around entire perimeter. Square feet is the length times width so to find how many sheets of Drywall repair near me are needed divide the total square feet by thirty two. This will give you the amount of four by eight sheets to purchase, get an extra one or two for errors. You will also need a screw gun, screws, drywall mud, a drywall knife, keyhole saw, drywall tape, mud pan, a six inch mud knife, eight inch mud knife, ten inch knife and sandpaper.
Before beginning the drywall work there should be an inspection done on the framing, electrical, insulation and plumbing. Begin with the ceiling and work down the wall when hanging drywall. The ceiling will require a jack or lift for ease in hanging a ceiling. Using the screw gun put a screw through the drywall into the frame every twelve inches. The screws should be in far enough to leave a recession to avoid popping out in later times.
After completing the ceiling begin hanging drywall on the wall starting at the top. For the best and sturdiest results hang each sheet in a staggered fashion. Working down the wall until reach the floor. There should be a gap of approximately 1/2 inch away from any sub flooring. Use the keyhole saw to cut around electrical boxes and a drywall saw for removing any excess length from the drywall sheets.
After all the drywall has been hung the remaining part of this process is to do the finishing. Put corner bead on the corners either by using mud or screwing into place, it will depend on the style of beading you have purchased.
Next using the six inch knife apply a layer of compound over a seam then place the drywall tape over the mud. Using the six inch knife and light pressure slide the knife over the tape starting in the center and working up, then from center down. The knife should have slight pressure and lay almost flush against the wall. This pulls the mud from the center out through the tape to make it adhere and lay flat. Using the small knife fill in all screw holes. Allow to dry overnight.